IMC Networks iMcV-LIM, 10/100-SM1310/LONG-ST Manuál s instrukcemi

iMcV-LIM 10/100 Operation Manual

7 LED Operation The iMcV-LIM features several diagnostic LEDs per port. The LED functions for the iMcV-LIM are LNK ACT 100 LFD AN PWR 100 ACT

8 Installation Troubleshooting • During installation, test the fiber and twisted pair connections with all troubleshooting features disabled, then en

9 Specifications Operating Temperature 32° - 104° F (0° - 40° C) Storage Temperature 20° - 160° F (-20° - 70° C) Humidity 5 - 95% (non-condensing) Pow

10 Fiber Optic Cleaning Guidelines Fiber Optic transmitters and receivers are extremely susceptible to contamination by particles of dirt or dust, whi

11 Electrostatic Discharge Precautions Electrostatic discharge (ESD) can cause damage to any product, add-in modules or stand alone units, containing

12 Safety Certifications CE: The products described herein comply with the Council Directive on Electromagnetic Compatibility (89/336/EEC) For fu

19772 Pauling • Foothill Ranch, CA 92610-2611 USA TEL: (949) 465-3000 • FAX: (949) 465-3020 www.imcnetworks.com © 2009 IMC Networks. All ri

ii FCC Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B computing device, pursu

iii Table of Contents FCC Radio Frequency Interference Statement ...ii Warranty...

1 About the iMcV-LIM 10/100 The iMcV-LIM is an SNMP-manageable, IEEE 802.3 single-conversion media conversion module which converts between: • 10Base-

2 Managed Modules To manage one or more iMcV-LIM(s), an SNMP agent must be present in the chassis. To configure Managed Modules, install the module fi

3 Unmanaged Modules Before installing, configure the iMcV-LIM modules for desired features. Refer to table which indicates the available features and

4 Dip Switch Feature Function DefaultS1 LFD Link fault detection available in forced mode only (S3 is ON) OFF S2 AN Auto Negotiation mode (plug-n-

5 Modes of Operation The iMcV-LIM allows for three modes of operation: • Auto Negotiation (AN) enabled by default • Force 10 • Force 100 The module

6 Auto Negotiation When connecting two modules between two end stations (devices such as switches, hubs and repeaters), all devices should ideally sup