Imc-networks iMcV-Giga-FiberLinX-II Uživatelský manuál stáhnout pdf (Strana 10)

III - Hardware Configuration

Before installing the module in a chassis, there are two features that must be selected

using the DIP switches. These selections are:

•

Enable or disable management on each port

(DIP switches 1, 2, and 3)

•

Configure the module as a standalone, a host, or a remote

(DIP switches 7 and 8)

DIP Switch Settings

Before installing the iMcV-Giga-FiberLinX-II, use the DIP switches to set the

hardware-configurable features. The DIP switches are located on switch SW1 on the

iMcV-Giga-FiberLinX-II card. Refer to the diagram and table for switch settings and

available features.

Switch Function Default Setting

Management on EXT MGMT port ON

Management on DATA port

OFF

Management on OPTICS or

UPLINK port

OFF

Factory use - Do not change

---

Factory use - Do not change

---

Factory use - Do not change

---

Remote Module OFF

Host Module OFF

Factory use - Do not change

---

Factory use - Do not change

---

Host/Remote and Standalone Units

The iMcV-Giga-FiberLinX-II can be used as a Host, Remote, or Standalone unit.

Refer to the

Application Examples

section for examples.

When two iMcV-Giga-FiberLinX-II units are used as a pair, configure one as a Host

unit (DIP switch 8 = ON) and the other as a Remote unit (DIP switch 7 = ON). As a

host unit, the iMcV-Giga-FiberLinX-II requests management information from the

attached remote unit. It then displays that information, along with its own, when

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

Žádné komentáře

Imc-networks iMcV-Giga-FiberLinX-II Uživatelský manuál Strana 10